[mit]

Появилось обновление по перепрошивке аудио компьютера расчитаного на русский rds Depend on Hardware Version, use dedicated disc for it as shown below; Table: Correspondence list of H/W Version and DiscH/WMelco Part Number & suffixDiscMMC Part Number & VersionSerial Number suffix"00.00"3AP134Disc for8750A070 all suffix, "00.01"3AP134A470 and 560 ohm8750A138 suffix G, J, K"00.02"3AP134B8750A139 suffix G, J, K"00.03"3AP134C8750A143 suffix K "00.04"3AP134D, 148D, 149D8750A169 suffix K"00.05"3AP134E, 148E, 149E, 150E, 168E"00.06"3AP148F, 149F, 150F, 168FDisc for 680 ohm8750A138, 139, 143, 169"00.07"3AP148G, 149G, 150G, 168Gsuffix M, N, P"00.08"3AP148H, 149H, 150H, 168H"00.09"3AP148I, 149I, 150I, 168IRe-programming 8750A138, 139, 143 suffix Q, S, V"00.10"3AP148J, 149J, 150J, 168J NOT possible8750A169 suffix Q, S"01.01"3AP178AA, 182AADisc for 680 ohm8750A170 suffix T 8750A184 suffix T, V"01.02"3AP178AB, 182ABDisc for8750A170 suffix X, Z"00.11"3AP148K, 149K470 and 560 ohm8750A138, 139, 184 suffix X, Z, AB"01.03"3AP178AC, 182AC"00.12"3AP148L, 149L"01.04"3AP178AD, 182ADRe-programming 8750A138, 139, 170, 184 suffix AC"00.13"3AP148M, 149M NOT possibleNote: H/W Version "00.09", "00.10", "01.04" and "00.13" (Serial Number suffix: “Q”, “S”, “V”, and "AC") are not possible to re-program the software because these use "Mask ROM".2. Re-programming(1) Return to "Service" menu by pushing "Back" soft key twice.(2) Push “Versions Indication” soft key on the screen (Fig.7). Then, you can see the versions of software in each sub-system (Fig.8). Check the version of the software in “Audio Microcomputer”. (See the above table.) Note: In case the MMCS is reprogrammed, version No. will be:“00.34.02 1A3402” or "00.34.02 2A3402".Bitmap

Fig.7 “Service” menu

Center Center Bitmap

Fig.8 Versions Indication

Center Center (3) Push "MENU" button located in the right lower corner on the panel more than 5 seconds (Fig.9). Then, "Loading Program" menu is displayed (Fig.10).(4) Push "Audio Microcomputer Load" soft key.Bitmap

Fig.10 Loading Program

Center Center

Fig.9 "MENU" button

Center Center (5) Push "OPEN" button located in the left lower corner on the panel (Fig.11).