[A.SH.]

У Ланса есть процедура инициализации. После подключения клеммы надо включить зажигание(но не включать стартер), выключить зажигание, и только потом осуществить пуск двигателя. При этой процедуре происходит самокалибровка дроссельной заслонки.
Мож и Аутов так?

LEARNING PROCEDURE FOR IDLING IN MPI ENGINEINITIALISATION PROCEDURE FOR THROTTLE VALVE CONTROL SERVO

Disconnecting and reconnecting the battery cables causes the throttle valve closed-position value learned to be erased from the memory. This may prevent the idle speed control from being executed properly. When the battery cables have been disconnected and reconnected, initialise the throttle valve control servo in the following manner.
1.Turn the ignition switch to "ON" and then to "LOCK" (OFF).
2.Keep the ignition switch in "LOCK" (OFF) for at least 10 seconds.